Assembling The Trimmer; Mounting The Bike Handle; Mounting And Removing The Deflector - Stihl FSA 130 Instruction Manual

6 Assembling the Trimmer

► If 3 LEDs on the battery flash red while you are checking
the controls: Pull connecting cable plug out of the
socket and contact your STIHL dealer for assistance.
There is a malfunction in the trimmer.
► If you cannot carry out these steps: Do not use your
trimmer and contact your STIHL dealer for assistance.
6 Assembling the Trimmer
6.1

Mounting the Bike Handle

► Switch off the trimmer and pull the connecting cable plug
out of the socket.
1
3
2
4
► Remove the wingscrew (1).
► Remove the upper clamp molding (2).
► Place the handlebar (3) in the lower clamp molding (4).
► Fit the upper clamp molding (2).
► Insert the wingscrew (1).
► Swing the handlebar (3) up.
► Tighten down the wingscrew (1).
► Take out the screw (6).
► Position the control handle (7) on the handlebar (3),
trigger facing the gearhead, and line up the hole in the
control handle with the hole in the handlebar.
► Fit the nut (7).
► Insert and tighten down the screw (6).
0458-726-9921-A
The loop handle (2) need not be removed again.
6.2
6.2.1
► Switch off the trimmer and pull the connecting cable plug
8
7
► Push the deflector (1) into the guides on the gear housing
6
► Insert and tighten down the screws (2) firmly.
3
6.2.2
► Switch off the trimmer and pull the connecting cable plug
► Take out the screws (2).
► Pull off the deflector (1).

Mounting and Removing the Deflector

Mounting the Deflector
out of the socket.
2
as far as stop.
Removing the Deflector
out of the socket.
2
English
1
1
47