Current Status Display; Menu Screen - Sherwood RD-7106 Operation Instructions Manual

U U s s i i n n g g t t h h e e O O S S D D
This unit incorporates an OSD(On-screen display) function to provide information about basic operation of this unit and to
simplify the set-up procedures.
The OSD function uses a monitor TV connected to this unit as a display and has two kinds of display modes; Current Status
Display and Menu Screen.
■Notes:
Any on-screen display shown on the monitor TV will not be recorded onto VIDEO 1.
In some countries, this unit allows you to select either NTSC or PAL color system as your video format.
If it is different from your video components and video software, etc., while in the standby mode, press the STANDBY
button while keeping the CHECK button pressed on the front panel, then the video format will change to the NTSC or the
PAL color system.
However, in some countries, only the NTSC system is available.

CURRENT STATUS DISPLAY

This mode shows the status corresponding to each operation.
The on-screen display will automatically disappear in 5 seconds.
For example, there are 2 status displays as follows.
When selecting the desired input source.
VIDEO 1 (OPTICAL 1)
Input source Signal input

MENU SCREEN

This function simplifies the set-up procedures for items such as the speaker mode, function select, surround
mode, delay time and channel level trim.
The menu screen operation is performed easily with the CURSOR control(▲, ▼, ◀, ▶), ON SCREEN
DISPLAY and ENTER buttons.
Turn the menu screen on.
1
DECK SEL.
6CH DIRECT
The main menu will be shown.
To turn the menu screen off, press this button,
again.
POWER P .SCAN
1 2 3 4 5
6 7 8 9 0
CD OSD ENTER
DISC
OSD
REPEAT INTRO
A B < <
A
B DECK
PRESET USER FILE T .MON DISPLAY
CD TUNER VIDEO
EQUALIZER
AUX TAPE MON. STEREO
AUTO DSP MODE
INPUT
SELECTOR
T .TONE CH SEL.
D.TIME ADJUST
CH LEVEL MASTER
DISPLAY SLEEP MUTE
SYS
When selecting the TEST TONE mode.
(( ))
FL C
SW
RL
FL -----------------
Channel level or overall volume display
When adjusting each channel level or overall volume, the
volume level display will be shown.
The test tone display will be shown until the test tone mode
is canceled.
MAIN MENU
SPEAKER MODE
FUNCTION SELECT
SURROUND MODE
DELAY TIME
CH LEVEL TRIM
up/down : MOVE
OSD : END
In the button of the display, "up" stands for the CURSOR
UP(▲) button. "down" for the CURSOR DOWN(▼),
"OSD" for the ON SCREEN DISPLAY and "ENTER" for
the ENTER button.
25
FR
RR
------------------- 0
ENTER : SELECT
Main menu display