Table of Contents
Advertisement
4.
With the lever open, insert the hard disk drive assembly into the chassis (see letter "E"). Push in the lever
to lock it into place (see letter "F").
2.7 Replacing the Power Supply
CAUTION: The power supply is only hot-swappable if you have a redundant system with two power supplies
installed. If you only have one power supply installed, before removing or replacing the power supply, you
must first take the system out of service, turn off all peripheral devices connected to the system, turn off the
system by pressing the power button, and unplug the power cord from the system or wall outlet.
The power supply can be replaced if it fails. To replace the power supply, follow these steps:
1.
Do one of the following:
If a power supply is installed, push the green latch in the direction shown while pulling the
-
power supply out of the system by the handle.
Intel® Storage Server System JBOD2000S3 Service Guide
Figure 20. Installing Hard Disk Drive – Installing 2.5" HDD
Figure 21. Installing Hard Disk Drive – Inserting 3.5" HDD Assembly
11
Advertisement
Table of Contents
