Operations; Listening To A Program Source - Sherwood R-765 Operating Instructions Manual

Operations

• Note : Before operating this receiver with the supplied remote control, refer to "Universal Remote Controls" on page 13 for
details about operation.

LISTENING TO A PROGRAM SOURCE

Before operation
• Enter the standby mode.
• The STANDBY indicator lights up.
When the power operation switch
is in the OFF or STANDBY state,
the apparatus is still connected on
some AC line voltages.
Please be sure to unplug the cord when you leave
home for, say, a vacation.
• To switch the power off, push the POWER switch again.
• Then the power is cut off and the STANDBY indicator
goes off.
In the standby mode, turn the power on.
1
STANDBY
ON/STANDBY
or
• In the operating mode, if the STANDBY button on the
remote control is pressed, the receiver is turned off and
enters the standby mode.
• In the standby mode, if the INPUT SELECTOR button
is pressed, the receiver is turned on automatically and
the desired input is selected.
Switch the speakers on.
2
SPEAKER
ON/OFF
• Then the SPEAKER indicator lights up and the sound
can be heard from the speakers connected to the
speaker terminals.
• When using the headphone for private listening, press
the SPEAKER button again to switch the speakers off.
POWER
ON/ OFF
POWER ON
T/V
1 2 3 4
5 6 7 8
9 0
+10
MACRO
M1 M2 M3
19
Select the desired input source.
3
INPUT SELECTOR
VIDEO
AUDIO
or
• Each time the "AUDIO" button on the front panel is
M1
pressed, the input source changes as follows;
TUNER CD TAPE
(frequency display)
• Each time the "VIDEO" button on the front panel is
pressed, the input source changes as follows;
VIDEO 1 VIDEO 2
When selecting the 7 CH DIRECT as desired,
INPUT SELECTOR
7CH DIRECT
T/V
1
5
or
9
M1 M1
• "7-DIRECT" is displayed and the 7 or 6 separate
analog signals from the component connected to this
input can be controlled only by channel level(s) and
volume depending on the surround back speaker
setting.
• Press the 7 CH DIRECT button or select the desired
input source to cancel the 7 CH direct function.
• These analog signals can be heard only, not recorded.
1 2 3 4
5 6 7 8
9 0
+10
MACRO
M1 M2 M3
T/V
TUNER
CD
AUX
TAPE
VIDEO 1
VIDEO 2
1 2 3 4 1
VIDEO 3
5 6 7 8 5
9 0 +10 9
MACRO
M2 M3 M1
AUX
T/V
VIDEO 3
2 3 4 1
6 7 8 5
7 CH IN
0 9
+10
MACRO MACRO
M2 M2 M3 M3 M1
T/V
2 3 4
6 7 8
0 +10
MACRO
M2 M3
T/V
2 3 4
6 7 8
0
+10
MACRO
M2 M3