Programming Id Lock; Using The Master Power Key - Universal Electronics M1055 User Manual

PROGRAMMING ID LOCK

TheAtlas Shaw DVR/PVR 5-Device Universal Remote
Control is locked at the factory to operate a Scientific
Atlanta cable converter. However, if you have another
brand or model of cable converter or satellite service
that you would like to control, then you'll need to
perform the following steps to unlock the ID Lock, enter
a new manufacturer's code, and lock the ID Lock again.
1. Turn on the cable converter.
On the remote control, press CBL once; it will
2.
blink once. Then press and hold SETUP until
the CBL key blinks twice.
3. Enter 9 8 2. The CBL key will blink four
times, indicating ID Lock is unlocked.
4. Perform the instructions under
"Programming Device Control" on page 8 to
program device control for the desired cable
converter or satellite receiver.
When you are done, perform steps 5 and 6 on
this page to again lock the ID Lock.
5. On the remote control, press CBL once; it will
blink once. Then press and hold SETUP until
the CBL key blinks twice.
6. Enter 9 8 2. The CBL key will blink twice,
indicating ID Lock is again locked.

USING THE MASTER POWER KEY

The Atlas Shaw DVR/PVR 5-Device Universal Remote
Control has a unique feature that allows you to
sequentially turn up to five of your home entertainment
devices on or off with a single key press.
NOTE: MASTER POWER (PWR) only works in the CBL
mode. If it is not programmed, only the cable
converter will turn on or off. In any other
mode, pressing MASTER POWER (PWR) once
will turn the selected device on or off.
18