Fig 08-09
lower it onto the mounting plate, see fig 10. Line up the holes in
the tilt quadrant with the ones in the mounting plate, replace
the bolts/washers and tighten. Lower the table down on its
stop, replace table insert and stabilising bolt, see fig 11-12-13.
DO NOT OVERTIGHTEN!
Fig 10-11-12-13
Fence Assembly
1) Locate the guide fence rail (3) and guide fence assembly (4).
Loosen the bolts beneath the table (2), giving enough
clearance between the table and bolts. Line up machined
slots in the fence rail (3) and slide the rail up against the table.
Nip up the bolts to secure the rail, see fig 14-15-16.
Loosen bolts
9
Assembly
Fig 14-15-16
3
Continues over...