Mounting The Saw Table - Axminster AC1950B Original Instructions Manual

Assembly

Mounting the Saw Table

Locate the blade tensioning knob (6) and insert it down over
the control shaft ,on top of the bandsaw housing, see fig 01.
1) The saw table can be fitted without removing the blade.
However, if you would feel more comfortable not having to
manoeuvre the table around the blade, remove the blade by
opening the top and bottom covers, release the tension on
the blade by backing off the tensioning wheel, see fig 02-03.
Fig 01
6
Fig 02-03
Table insert removed
2) Locate the cast iron table (2), remove the table stabilising
bolt and the table insert, see fig 04-05. Angle the tilt quadrant
assemblies base by loosening the two lift and shift handles
beneath the table in readiness for mounting, see fig 06-07.
3) Remove the bolts, washers/spring washers from the
bandsaws mounting plate and place safely aside, see fig 8-9.
Lift the table (2), slide the blade through the table,s slot and
8
Fig 04-05
Table stabilising bolt
2
Fig 06-07