Displaying The Black Screen; Displaying And Setting The Break Timer - Sharp XG-PH70X-N Operation Manual

Image Projection
Displaying the Black
Screen
This function allows you to tempo-
rarily display the black screen.
1
Press .
2
Pressing
the projected image back on.
Displaying and Setting
the Break Timer
This function allows you to show the re-
maining time for break during meeting.
1
Press .
2
While " " is displayed, press
', ", \ or | to set the break
timer.
• You can set anywhere between 1 and
60 minutes (in 1 units).
• The break timer starts to count down as
soon as ' ' ' ' ' , " " " , \ \ \ \ \ or | | | | | is pressed. " "
Note
• Pressing will cancel the break timer.
• Auto Power Off function will be temporarily
disabled during the break timer.
When no input signal is detected for more
than 15 minutes, the projector will automati-
cally enter the standby mode if the break
timer has elapsed.
• The break timer will be displayed on the
startup image. To change the screen dis-
played during the break timer, change the
setting of "Startup Image" (see page 77).
• When "Slave" is set for "Stack Setting", the
break timer is not displayed. (See page 84.)
-50
again will turn
▼Projected Image
BREAK TIMER
button
▼On-screen Display
BLACK SCREEN
button
Mouse/
adjustment
button
( ' / " / \ / | )
UNDO
button