Replacing The Air Filter - Sharp XG-C60X Operation Manual

Replacing the Air Filter

• This projector is equipped with air fil-
ters to ensure the optimal operating
condition of the projector.
• The air filters should be cleaned ev-
ery 100 hours of use. Clean the filters
more often when the projector is used
in a dusty or smoky location.
• Ask your nearest Sharp Authorized
Projector Dealer or Service Center to
exchange the filter (PFILDA005WJZZ)
when it is no longer possible to clean.
Cleaning and replacing
the bottom air filter
1
Press
STANDBY
or on the remote control to
put the projector into the
standby mode.
• Wait until the cooling fan stops.
2
Disconnect the power cord.
• Unplug the power cord from the AC
socket.
3
Remove the bottom filter cover.
• Turn over the projector. Grab the tab
and slide open the filter cover in the
direction of the arrow.
4
Remove the air filter.
• Pick the air filter up with your fingers
and lift it out of the filter cover.
XG-C60X_E_PDF_p79_93.p65
on the projector
81
M4
M4
Air filter (not removable)
STANDBY button
AC socket
Tab
03.9.14, 4:17 PM
M4
M4
Air filter
STANDBY
button
-81