Setting the Video System
The video input system mode is preset to "Auto"; however, a clear picture from the con-
nected audio-visual equipment may not be received, depending on the video signal differ-
ence. In that case, switch the video signal.
Setting the Video
System
Select "Video System" in the "Options
(1)" menu on the menu screen.
➝ For operating the menu screen, see
pages
42 to
45.
Note
The video signal can only be set in IN-
PUT 3 or INPUT 4 mode.
When the system mode is set to "Auto",
you may not receive a clear picture due
to signal differences. Should this occur,
switch to the video system of the source
signal.
-66
-66
XG-C60X_E_PDF_p60_66.p65
66
PAL
When connected to PAL video equipment.
SECAM
When connected to SECAM video
equipment.
NTSC4.43
When reproducing NTSC signals in
PAL video equipment.
NTSC3.58
When connected to NTSC video equipment.
03.8.28, 2:26 PM