Sharp XG-C60X Operation Manual page 39

3
Press ,
the remote control to select the
INPUT mode.
After pressing
use to select the desired input mode.
Note
When no signal is received, "NO
SIGNAL." will be displayed. When a
signal that the projector is not pre-
set to receive is received, "NOT
REG." will be displayed.
When "Auto Search" is "ON", the
INPUT modes with signals can be
selected. (see page 64.)
The INPUT mode is not displayed
when "OSD display" is set to "Level
A" or "Level B". (see page 65.)
About the INPUT modes
INPUT 1 Used for projecting im-
INPUT 2 ages from equipment that
(RGB/ sends RGB signals or
Component) component signals con-
nected to the RGB input
terminal.
INPUT 3 Used for projecting im-
(Video) ages from equipment
connected to the VIDEO
input terminal.
INPUT 4 Used for projecting im-
(S-Video) ages from equipment
connected to the S-
VIDEO input terminal.
4
Press or
control to adjust the volume.
Note
Pressing
Pressing
On the projector, the volume can be
adjusted by pressing
, on the projector operate
as cursor buttons (\, |) when the
menu screen is active.
XG-C60X_E_PDF_p33_41.p65
, or on
once on the projector,
on the remote
will lower the volume.
will raise the volume.
or .
35
"On-screen Display (Example)
INPUT 1 mode
Using RGB
Using
Component
INPUT 2 mode
Using RGB
Using
Component
INPUT 3 mode
Using Video
INPUT 4 mode
Using S-Video
INPUT
buttons
03.8.28, 2:08 PM
VOLUME
buttons
-35