Sharp Notevision PG-A10S Operation Manual page 31

3
Press ,
remote control to select the IN-
PUT mode.
• After pressing
use to select the desired input mode.
Note
• When no signal is received, "NO SIG-
NAL" will be displayed. When a signal
that the projector is not preset to re-
ceive is received, "NOT REG." will be
displayed.
• The INPUT mode is not displayed
when "OSD Display" is set to "OFF".
(See page 44.)
About the INPUT mode
INPUT 1 Used for projecting im-
(RGB/ ages from equipment that
Component) sends RGB signals or
component signals con-
nected to the RGB input
terminal.
INPUT 2 Used for projecting im-
(S-Video) ages from equipment
connected to the S-
VIDEO input terminal.
INPUT 3
Used for projecting im-
(Video)
ages from equipment
connected to the VIDEO
input terminal.
4
Press or
control to adjust the volume.
Note
• Pressing
Pressing
• On the projector, the volume can be
adjusted by pressing
5
Press
trol to temporarily display a
black screen and turn off the
sound.
Note
• Pressing
jected image and sound back on.
A10X_A10S#E_Print#p26_31.p65
or on the
once on the projector,
on the remote
will lower the volume.
will raise the volume.
or .
on the remote con-
again will turn the pro-
27
"On-screen Display (Example)
INPUT 1 mode
Using RGB
Using
Component
INPUT 2 mode
Using S-Video
INPUT 3 mode
Using Video
03.2.4, 2:04 PM
27