Table of Contents
Advertisement
Settings
Setting the transmission
channel (UTX-B1 only)
See "Wireless microphone system frequency list" on
page 26 for details on the selectable channel groups
and channels.
1
Turn on the transmitter while pressing
down the SET button.
Keep pressing the SET button until the
display section parameters that were
displayed when the unit was last turned
off start to flash.
2
Press the SET button repeatedly until
the channel number (or frequency)
indication appears.
3
Press the + or – button to select the
channel number (or frequency).
Pressing the + button cycles the
indication in the order shown in the
tables in "Wireless microphone system
frequency list" on page 26.
Pressing the – button cycles the
indications in the opposite direction.
Hold down the + or – button to change
the channel number (or frequency)
faster.
4
When the desired channel number (or
frequency) appears, set the POWER
switch to OFF to complete the setting,
or press the SET button to set other
items.
The results are stored in memory. The
stored channel number (or frequency)
will appear in the display section the
next time you turn on the transmitter
by setting the POWER switch to ON.
Notes
• When you are setting the transmission
channel, the transmitter cannot be used to
transmit signals.
• Do not remove the batteries while setting
the transmission channel. If they are
inadvertently removed, re-insert them
immediately and redo the procedure
"Setting the transmission channel (UTX-
B1 only)" from step 1.
• Make sure that the selected channel is the
same on the transmitter and tuner being
used in the same system.
• If you turn off the transmitter and then
immediately turn it on right after setting
the transmission channel, the unit may
not operate normally. Wait a few seconds
before turning it on again.
Setting the reception
channel (URX-M1 only)
See "Wireless microphone system frequency list" on
page 26 for details on the selectable channel groups
and channels.
1
Press down the SET button for more
than one second.
Keep pressing the SET button until the
display section parameters start to
flash.
2
Press the SET button repeatedly until
the channel group and the channel
number indications appear.
The channel group indication starts to
flash.
3
Press the + or – button to select the
channel group.
Settings
15
Advertisement
Table of Contents
