Configuration - Mackie DRM212 Owner's Manual

Configuration

This is where to recall / store settings to memory,
lock access to the settings, select Ch. 2 input setting
and more.
MAIN
EQ
This is similar to what you will see after first entering
the configuration screen. The current Ch2 in, backlight
and front LED settings will be illuminated.
CONFIGURATION
MEMORY
LOCK PIN
CH2 IN
BACKLIGHT
FRONT LED
RESET
ABOUT
To change a setting, just rotate the speaker
control knob until the configuration you desire
to change is illuminated, then push to select it.
These are the choices from top to bottom:
Memory – When memory is selected, settings may be
saved to memory and recalled at a later time. No more
having to reset levels, EQ, voicing, etc. upon every
power-up.
CONFIGURATION
MEMORY
LOCK PIN
CH2 IN
BACKLIGHT
FRONT LED
RESET
ABOUT
CONFIGURATION
MEMORY
LOCK PIN
User memory
CH2 IN
BACKLIGHT
RECALL
FRONT LED
RESET
ABOUT
16
DRM Professional Powered Loudspeaker Series
MODE SUB
DELAY CONFIG
1 2 3 4 5 6
1 2 3 4
LO-Z HI-Z
OFF DIM ON
OFF ON
1 2 3 4 5 6
1 2 3 4
LO-Z HI-Z
OFF DIM ON
OFF ON
1 2 3 4 5 6
MEMORY
1 2 3 4
LO-Z HI-Z
3:
OFF DIM ON
STORE
OFF ON
There are six user memory snapshots which should
be more than enough.
Store – Tap this to store the current settings
to the corresponding memory snapshot.
Please be aware that the new settings
will replace the currently saved settings.
Recall – Tap this to recall the settings of the selected
memory snapshot.
Illuminating and selecting the left-facing arrow
returns you to the previous screen.
Lock Pin – This is where to lock and unlock the
interface with a secret 4-digit numeric password.
Rotate the speaker control knob until lock pin
is illuminated, then push in to enter lock mode.
From here, rotate the speaker control knob until
the first number you desire is illuminated and press
to select. Follow the same procedure for the next
three numbers.
As seen below, we decided to go with 1-2-3-4 because
that's (a "5" shy of) the same code that was used
on Spaceballs. A confirmation dialog helps prevent
accidents. No further changes may be made until
the control access is unlocked.
CONFIGURATION
MEMORY
LOCK PIN
CH2 IN
BACKLIGHT
FRONT LED
RESET
ABOUT
CONFIGURATION
MEMORY
LOCK
LOCK PIN
Lock user
CH2 IN
interface?
BACKLIGHT
YES
FRONT LED
RESET
ABOUT
Unlocking – If you try to make any changes
or select anything, you will be asked to enter
the pin. Here you will need to re-enter the 4-digit
code and push the speaker control knob to unlock.
1 2 3 4 5 6
1 2 3 4
LO-Z HI-Z
OFF DIM ON
OFF ON
1 2 3 4 5 6
1 2 3 4
LO-Z HI-Z
OFF DIM ON
NO
OFF ON