Test & Sw2 Buttons; Memory Card; Factory Superheat Setting; Superheat Offset Dip Switch Settings - Rheem ECONET RP2024BJVCA Installation Instructions Manual

7.5 EcoNet
7.5.2 TEST and SW2 Buttons
TEST and SW2 buttons are used to enter the
following menus and modes:
• Test mode
• Forced Defrost
• Fault Code Recall Menu
• Compressor Speed Menu
• Superheat Menu
Outdoor Unit
(-­‐)P1724
(-­‐)P1736
(-­‐)P1748

7.5.5 Superheat Offset DIP Switch Settings

(-­‐)P1760
(DIP Switch Bank on the Right)
Although the factory programmed superheat
setting is considered to be the most efficient
setting for each unit, installation conditions can
effect the measurement of superheat on the
Superheat Off Set from
Offset Selection Programmed
Profile Setting (°F)
A
B
C
D

7.5.6 Defrost Termination Temperature DIP Switches

(DIP Switch Bank on the Left)
Off
Off
On Off
Off On
On On
7.0 COMPONENTS & CONTROLS
Variable Speed Outdoor Control (VSODC) (cont.)
™
Superheat
(°F)
6
6
6
8
0
-­‐4
-­‐2
+2
60 F [15.6 C]
º º
50 F [10 C]
º º
40 F [4.4 C]
º º
70 F [21.1 C]
º º

7.5.3 Memory Card

• The memory card stores all unit information.
• The unit information is called model data.
• The model data is all the information needed for
proper unit operation of that specific model.

7.5.4 Factory Superheat Setting

Dipswitch Settings
1
The VSODC is pre-programmed with the optimum
Off
superheat setting of 6º for each outdoor unit.
Off
Off
Off
VSODC. For this reason the following dip switch
settings have been provided to enable flexibility for
various installation conditions.
2
Off
Off
Off
Off
35