Sensor Failure Default Operation; Exiting Active Protection Lock-Out Mode - Rheem ECONET RP2024BJVCA Installation Instructions Manual

8.0 ACTIVE SYSTEM PROTECTION FEATURES

8.13 Sensor Failure Default Operation

If the controls sense an externally connected
sensor has failed, the system will enter a fail safe
operating mode and will continue to condition the
space until the sensor can be replaced. A fault

8.14 Exiting Active Protection Lock-Out Mode

Exiting an Active Protection Lock-Out mode can
be accomplished by disconnecting electrical power
to both the indoor and outdoor units for 1 minute
and then restoring power. Keep in mind there
was a reason for the lock-out, so the fault code on
42
code will be displayed on the EcoNet
Center and Variable Speed Outdoor Control
identifying which sensor has failed. See the table
below for the default operation for a sensor failure.
the Variable Speed Outdoor Control (VSODC) or
EcoNet Control Center should be read to assist
TM
with diagnosing the root cause of the lock-out and
corrective action should be taken to prevent the
system from repeating the lock-out.
Control
TM