Table of Contents
Advertisement
Display Messages
Messages and Signals
Display messages
Note: If you have turned on the Caller ID function, see Caller ID in
Chapter 7 for display messages related to Caller ID.
A.M. TRANSFER
COVER OPEN
DOCUMENT JAMMED
FAX RX IN MEMORY
FILM END
FUNCTION MODE
LINE ERROR
LINE IS IN USE
136
The answering machine's transfer function has been
turned on as explained in Transfer Function in
Chapter 2.
The print compartment cover (under the operation
panel) is open. Open the operation panel (grasp the
top and pull toward you), and then press down firmly
on both sides of the print compartment cover to close
it.
The original document is jammed. See the following
section, Clearing Paper Jams .
A fax has been received in memory because the
imaging film needs replacement, you have run out of
printing paper, or the paper is jammed. The fax will
print out automatically when the problem is fixed.
The imaging film may need replacement. Check the
film and replace if necessary.
The FUNCTION key has been pressed.
Transmission or reception was not successful. Press
STOP to clear the message, and then try again. If the
error persists, see Line Error in Problems and
Solutions in this chapter.
An extension phone connected to the fax is being
used. Do not lift the fax's handset or attempt
transmission at this time, as this will interrupt the
conversation on the extension phone.
Advertisement
Table of Contents
