Setting The Date And Time - Sharp UX-340LM Operation Manual

Setting the Date and Time

Setting the Date and Time
The date and time appear in
the display and are printed at
the top of every page you fax.
Set the date and time by pressing the
keys on the operation panel as shown
below.
Do not set the date and time if
you are using OpenLCR!
OpenLCR automatically sets the
date and time each time your fax
calls OpenLCR and receives rate
data. To ensure accurate use of the
rate data, do not change the date
and time setting yourself.
OpenLCR also sets the date and
time for you if you perform the fax
transmission test (see page 30).
3 key
1 2 3
4
5 6
7 8 9
0
* * * * key
STOP key
22
FUNCTION key
START/
MEMORY
key
Note: The imaging film and printing
paper must be loaded before the date
and time can be set.
1
Press these keys:
FUNCTION
The display will show:
DATE & TIME SET
2
Press the START/MEMORY key.
START/MEMORY
The currently set date will appear in
the display.
3
Enter a two-digit number for the
month ("01" for January, "02" for
February, "12" for December, etc.).
0
To correct a mistake, press the
SPEED DIAL key to move the
cursor back to the mistake and then
enter the correct number.
3
Press 4
times
1
Example: January