Table of Contents
Advertisement
1.
Install a standard 1/4" Air Connector (not included) to the Air Inlet (1). First
wrap the threaded portion of the 1/4" air connector with pipe thread seal tape
before threading it into the Air Inlet (1). Tighten securely.
2.
Attach a standard quick connector (not included) to your air pressure source
hose. Then attach the air hose to the Pin Stripe Remover.
NOTE: If you are not using an automatic inline oiler, add a few drops of
pneumatic oil to the Air Inlet (1) before attaching the air hose. Add a few
more drops of oil after every hour of continual use.
3.
Set the air pressure regulator at 90 psi.
WARNING: DO NOT INCREASE THE AIR PRESSURE to the tool beyond 90
psi. This may damage the tool, or cause personal injury.
4.
Check the air line and its connections for air leaks. Make note of these, and
repair them before using this tool.
NOTE: We recommend the use of inline filter, regulator, and oiler in any com-
pressed air system using tools purchased from Harbor Freight Tools. Please refer
to the schematic below for a suggested system set up. These components are not
included in this kit, but are available from Harbor Freight Tools.
Pin Stripe
Remover
CAUTION: Disconnect the air pressure
hose before changing pads or making
any adjustments to this tool. Severe
injury or property damage may other-
wise result.
5.
To remove the Pad (36), remove the
Arbor (35), the washer and old Pad.
Do this by holding the Pad while
turning the Arbor (35) counterclock-
wise with the Arbor Wrench (38).
SKU 93048
For technical questions and replacement parts, please call 1-800-444-3353
Operation
Installing an eraser pad
Page 5
Advertisement
Table of Contents
