Table of Contents
Advertisement
Problem
Tool will not start
Tool operates slowly
Performance
decreases over time
Excessive noise or
rattling
Overheating
Follow all safety precautions whenever diagnosing or servicing the
tool. Disconnect power supply before service.
SKU 67097
For technical questions, please call 1-800-444-3353.
Troubleshooting
Possible Causes
1.
Battery Pack needs charging.
2.
Battery Pack not properly seated.
3.
Connection to Battery pack
damaged.
1.
Battery Pack needs charging.
2.
Job is for a more powerful tool.
1.
Accessory dull or damaged.
Internal damage or wear. (Carbon
brushes or bearings, for example.)
1.
Forcing tool to work too fast.
2.
Accessory misaligned.
3.
Accessory dull or damaged.
4.
Blocked motor housing vents.
Likely Solutions
1.
Charge Battery Pack.
2.
Check that Battery Pack is fully inserted
into tool so that it snaps into place.
3.
Check that the terminals inside the tool
are not bent or missing. Have repaired by
a qualified technician if needed.
1.
Charge Battery Pack.
2.
Use a stronger powered tool.
1.
Keep cutting accessories sharp.
Replace as needed. Replace sandpaper
when it becomes worn or torn.
Have technician service tool.
1.
Allow tool to work at its own rate.
2.
Check and correct alignment of
accessory.
3.
Keep cutting accessories sharp.
Replace as needed.
4.
Wear ANSI-approved safety goggles and
NIOSH-approved dust mask/respirator
while blowing dust out of motor using
compressed air.
Page 9
Advertisement
Table of Contents
