Table of Contents
Advertisement
Problem
1. No power at outlet.
2. Cord not connected.
Tool will not heat
3. Heat Control Knob in OFF
Follow all safety precautions whenever diagnosing or servicing the
tool. Disconnect power supply before service.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT
HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS
QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/
OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD
BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE
BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER
INSTALLATION OF REPLACEMENT PARTS THERETO.
Item 62133
Troubleshooting
Possible Causes
position.
PARTS LIST
Part
1
Handle Set w(8) Screws
Cord Set (Relief Spring, Wire Connection
2
Clip, two Screws
Thermostat w/ Extension Post for Control
3
Knob
4
Top Sole Plate w/five Screws
5
Bottom Sole Plate, Aluminum, Flat
6
Iron Holder
7
Internal Wire Set (2 pieces)
8
Heat Control Knob
9
Heat Shield w/2 Screws and (1) Washer
Gasket (Top of heat shield for Handle
10
Mount)
Gasket (Between Heat Shield for top of
11
Sole Plate)
12
Heating Element
For technical questions, please call 1-888-866-5797.
Likely Solutions
1. Check power at outlet.
2. Check that cord is plugged in.
3. Turn Heat Control Knob to a heat setting
position.
Description
Page 10
Advertisement
Table of Contents
