Troubleshooting - Chicago Electric 62397 Owner's Manual

Troubleshooting

Problem
Tool will not start. 1. Cord not connected.
2. No power at outlet.
3. Internal damage or
wear. (Carbon brushes
or switch, for example.)
Performance 1. Accessory dull or damaged.
decreases
2. Carbon brushes worn
over time.
or damaged.
Excessive noise Internal damage or
or rattling. wear. (Carbon brushes or
bearings, for example.)
Overheating. 1. Forcing tool to work too fast.
2. Accessory dull or damaged.
3. Blocked motor housing
vents.
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect power supply before service.
Page 12
Possible Causes
For technical questions, please call 1-888-866-5797.
Likely Solutions
1. Check that cord is plugged in.
2. Check power at outlet. If outlet is unpowered, turn off tool
and check circuit breaker. If breaker is tripped, make sure
circuit is right capacity for tool and circuit has no other loads.
3. Have technician service tool.
1. Keep cutting accessories sharp. Replace as needed.
2. Have qualified technician replace brushes.
Have technician service tool.
1. Allow tool to work at its own rate.
2. Keep cutting accessories sharp. Replace as needed.
3. Wear ANSI-approved safety goggles and
NIOSH-approved dust mask/respirator while blowing
dust out of motor using compressed air.
Item 62397