Feature History For Layer 2 Interface Parameters - Cisco Nexus 1000V Configuration Manual

Configuring Layer 2 Interfaces
switch(config-if)# switchport access vlan 5
switch(config-if)#
This example shows how to configure a Layer 2 trunk interface, assign the native VLAN and the allowed
VLANs, and configure the device to tag the native VLAN traffic on the trunk interface:
switch# configure terminal
switch(config)# interface ethernet 2/35
switch(config-if)# switchport
switch(config-if)# switchport mode trunk
switch(config-if)# switchport trunk native vlan 10
switch(config-if)# switchport trunk allowed vlan 5, 10
switch(config-if)# exit
switch(config-if)# vlan dot1q tag native
switch(config-if)#

Feature History for Layer 2 Interface Parameters

Feature Name
Layer 2 interface parameters
Releases
4.0(4)SV1(1)
Cisco Nexus 1000V for VMware vSphere Interface Configuration Guide, Release 5.x

Feature History for Layer 2 Interface Parameters

Feature Information
This feature was introduced.
33