System Connections; Wiring For The 2-Pin Connector; Wiring For The 10-Pin Connector - Briggs & Stratton 040213 Service And Troubleshooting Manual

Service & Troubleshooting Guide - Home Generator System - Models 040213 and 040234 (15kW)
Section 1 - General Information

SYSTEM CONNECTIONS

Wiring For The 2-Pin Connector:

- Use to hook up the 240V utility leads
240 Volt Utility
from the transfer switch to the generator.

Wiring For The 10-Pin Connector:

- Use NO, COM and NC to hook up a
Fault Contacts
siren, light, etc. to alert you in case of a fault. Contacts
reverse state upon a fault condition.
10 Pin Connector
Fault Contacts
Transfer Switch
Communications
Remote LED Output
+12VDC,.5Amp Output
240VAC Utility
2 Pin Connector
Remote LED Output:
LED supplied with the generator. The remote LED will
turn on and off in a series of blinks if certain faults are
detected in the generator.
Transfer Switch Communication
GND to transfer switch and optional wireless
™
StatStation to monitor generator functions and for
FC_8 sensing.
+12 Volt DC, .5AMP Output
- Use this to hook up the remote
- Use TxRx and TxRx
- Internal power supply.
1
Page 17