Rinnai RHFE-556FA Owner's Operation And Installation Manual page 35

,f-
~jL-_P~R_O_G_R_A_M_M_IN_G_T_H_E_O_N_I_O_FF_.
·_TI_M_E_R
CS
>
~'<j
Before programming the Timers you must ensure that the clock has been set to the correct time.
See page
32.
As an example, let's program Timer 1 to heat the room by 7:10AM and finish at 9:00 AM.
Press the Set Times button twice. The Digital
Display will show AM 6:00. Timer 1 indicator
will flash.
Clock 0
,1,
Timer 1".:on 0 off
Timer 20 0
.
,
Press the
U
A ..
button until AM 7:00 appears,
release the button, then press it again until AM
7: 10 appears. (Press the
U
V" button if you go
past AM 7:10.)
Press the Set times button again, the Timer 1
OFF indicator will flash. Press the
U
A .. button
until AM 9:00 appears.
Press the Set Times button three times to lock
in the programmed time. The Digital Display
will show the current time. A small indicator on
the Digital Display will flash to show that the
Display has returned to the clock.
TURN TO NEXT PAGE TO OPERATE THE TIMERS.
Clock 0
Timer
1~";on
0 off
Timer 20 0
Clock 0
AM
PM Timer 1 0 on 0 off
Timer 20 0
TIMER 2 is programmed in the same way, remember to ensure that the Timer 2 indicator is
flashing when you program in the desired setting.
The Timers can be programmed to operate for any two periods in any 24 hours. Turn to next page
to operate the dual timer.
The programmed time must be selected and locked-in within one minute of the On Timer
indicators flashing otherwise the programmed times will not be reta.ined in the system memory.
-33-