Rinnai RHFE-556FA Owner's Operation And Installation Manual page 29

Energysaver gas direct vent wall furnace
Hide thumbs Also See for RHFE-556FA:
Table of Contents

Advertisement

(,
ROOM TEMPERATURE DISPLAY
Temperature is indicated by the digital read out above
the temperature/time adjustment buttons. The room
temperature is indicated by the digital display above
room. The set temperature is indicated by the digital
display above set. You will notice the fan speed
changing as the heater modulates to match the room
temperature.
LO 60 64 68 72 76 80 HI
oop:-ooeoo
TEMPERATURE LEVEL
AM •• -,- • ,-.,
PM
DO· DO
Set . Room
TO TURN UNIT OFF
Depress ignition ON/OFF button again.
The switch will return to the off position.
Do not turn off unplugging at the power outlet.
Convection fan continues to run until heater is cool. The
convection fan may start again after a few minutes to
remove any residual heat.
ECONOMY BUTTON
( / To select 'Economy Mode', push the 'Economy' button,
J
the green lamp will glow. 30 minutes after the room
[
!,
temperature reaches the preset temperature (set by the
. 1
thermostat), the 'Economy Mode', if set, reduces the
temperature by 2°F, after another 30 minutes it reduces
the temperature by a further 2°F, this is an energy
saving feature. When the heater is running in lowest
position on the thermostat, the 'Economy Mode' does
not operate. It does not operate if the heater is under
capacity for the room size.
FILTER LAMP
If the filter lamp glows during operation, check air filter
for dust. If there is dust present, clean filter. See
section on care of heater. Turn heater off before
cleaning filters.
<556FA >
<5q6FTRA>
IGNITION BUTTON
o
Filter
OON-~
ECONOMY
o
Economy
:(j- Filter
'.·ON-~
OPERATING PRECAUTIONS
Please read this section carefully, before using your Forced flue heater.
C' J
Gas Type, Power Source, and Manufactured Date
J •
Type of gas, power source and manufactured date are displayed on the nameplate placed on the
( )
right side of the unit.
(
Do .not use gas other than the type of gas (gas group) indicated on the nameplate.
This equipment is for 120 V AC (60Hz) only. Do not use power source other than what is listed.
-27-

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rhfe-556ftra

Table of Contents