Glossary Of Terms For Woodworking; Recommended Accessories; Trouble Shooting - Craftsman 113.23611 Owner's Manual

diagram
BLACK
wHITE ....
GREEN: ....
SWITCH
,,
recommended accessories
Item Sears Number
Leg Set 9-22244
Blades See Catalog--For 5" long,
pin end type blades
9-26873--medium radius cuts in wood up to 11/2" thick
9-26879--fine radius cuts in wood up to 1/4" thick
The above recommended accessories are current and were
available at the time this manual was printed.
glossary of terms
for woodworking
1. Kerf--the slot cut by the blade
2, Leading Edge--the edge of the work piece which is
pushed into the blade first.
3, Sawblade Path--The area of the workpiece directly
in line with and moving toward the sawblade edge.
4. Blade Tooth Set--the distance that the edge of the
sawblade tooth is bent (on set) outward from the side
of the blade.
=
6.
Trailing Edge--the workpiece edge last cut by the
sawblade.
trouble shooting
Work Piece--the item on which the cutting operation
is beina preformed.
WARNING: FOR YOUR OWN SAFETY, TURN SWITCH "OFF",
REMOVE KEY AND REMOVE PLUG FROM POWER SOURCE
OUTLET BEFORE TROUBLESHOOTING YOUR SCROLL SAW.
PROBLEM PROBABLE CAUSE REMEDY SUGGESTED
Breaking Blades.
Motor will not run.
Vibration
NOTE: There will always
be some vibration present
when the saw is running
because of the motor
operation.
1. Wrong tension.
2. Over working blade.
3. Wrong blade application.
4. Twisting blade in wood,
1. Defective cord or plug.
2. Defective motor.
..... ,, ,,,,,
1. improper mounting of saw.
2. Unsuitable mounting
surface.
3. Loose table or table
resting against motor.
4, Loose motor mounting
Blade Runout--Blade not Blade holders not aligned
in-line with arm motion
1, Adjust blade tension.
2. Reduce feed rate.
3, Use narrow blades for cutting thin wood, wide
blades for thicker wood.
4. Avoid side pressure on blade.
1,
2.
1,
2,
.
4.
1.
Replace defective parts before using saw again.
Consult Sears Service, Any attempt to repair this
motor may create a HAZARD unless repair is done
by a qualified service technician. Repair service is
available at your nearest Sears Store.
See mounting instructions in this manual for proper
mounting technique.
The heavier your work bench is the less vibration
will occur, A plywood workbench will not be as good
a work surface as the same size solid lumber. Use
common sense in choosing a mounting surface,
Tighten table lock knob.
Tighten motor mounting screws,
Loosen cap screws holding blade hoiders to arms.
Adjust position of blade holders--Retighten holders.
17