Advertisement
4. Locatewasher
6.5 x 17.8 x 1.6 and knob among loose
pads,
5. Position table support in corresponding holes on side
of base as shown.
Make sure the 9.5ram diameter
index pin aligns with upper hole,
6, Place washer on threaded shaft of knob and insert
through slot into threaded holes of base
///
SUPPORT
WARNING:
To avoid trapping the work or fingers
between the table and sanding surface, the table
edge should be a maximum of 1/16 inch from sand-
ing surface.
7, Loosen the (3) hex head screws and adjust table.
f
@
li161NCH
MAXIMUM
SURFACE
TABLE
8. Use your Owner's Manual as a spacer.
Place ten
pages of the Owner's Manual between the Disc and
the front edge of the table. Hold the table against the
manual and tighten the three (3) Hex Washer Head
screws.
_\_
OWNERS
MANUAL
0
,
i
4
/'0
0
"
10 PAGES
f
SCALE
LABEL
TABLE
LOCK
KNOB
9
Advertisement
