Advertisement
3. Slide tension lever to the left to apply belt tension.
4. Tighten hex socket screw when bed is in desired
position.
5. Plug in the power cord. Turn switch "ON" and imme-
diately "OFF," noting if the belt tends to slide off the
idler pulley or drive pulley. If it did not tend tOslide off,
it is TRACKING properly.
TENSION
LEVER
6. If the sanding belt moves toward the disc, turn the
tracking knob clockwise 1/4 turn.
7. If the sanding belt moves away from the disc, turn the
tracking knob counterclockwise
1/4 turn.
8. Turn switch "ON" and immediately "OFF" again, not-
ing belt movement.
Readjust tracking knob if neces-
sary.
TRACKING
KNO_
!I
Advertisement
