Advertisement
maintenance
WARNING:
For your own safety, turn switch "OFF"
and remove plug from power source outlet before
adjuSting, maintaining,
or lubrlcsting your belt and
disc sander.
WARNING:
TO avoid electrocution
or fire, any re-
pairs to electrical systems should be done only by
qualified service technicians.
Unit must be reas-
sembled exactly to factory specifications.
If powercord is worn orcut, ordamaged in anyway, have
it replaced immediately.
Frequently blow out or vacuum out any dust that may
accumulate inside the motor.
A coat of automobile-type
wax applied to the worktable
will make it easier to feed the work while finishing.
Do not apply wax to the abrasive belt table because the
belt could pick up the wax and deposit it on the pulleys,
causing the belt to slip.
LUBRICATION
The BALL BEARINGS in this machine are packed with
g rease at the factory. They require no further lubrication.
Sleeve bearings should be lubricated with 30 weight oil
or equivalent after each 10 hours of operation.
BLACK
RE_
WHITE
1
BLACK
JUMPER
POWER
CORD
2
WHITE
WIRING DIAGRAM
REMOVING
PULLEY
COVER AND
INSTALLING
DRIVE BELT
1. Using a phillips screwdriver,
remove the flat head
screw located in the middle of the cover.
2. Remove the cover.
PHILLIPS
SCREWDRIVER
PULLEY
COVER
3. Loosen (3) screws to allow pulleys to shift enough to
place belt around them.
Place belt around motor
pulley and d rive pulley as shown if belt is ever broken.
BELT
MOTOR
PULLEY
SCREWS
19
Advertisement
