Advertisement
basic operation
Always sand outside curves on the left side ofcenter on
the sanding disc as shown.
WARNING: Applying the workplece to the right side
of the disc could cause workplece to fly up (kick-
back) and result In an Injury.
WORKPIECE
SANDING
DISC
SANDING
SMALL
END SURFACES
ON
THE SANDING
DISC
NOTE:
Use of a Miter Gauge (optional accessory) is
recommended for this operation.
Always move the work across left side of center on the
sanding disc face as shown,
WARNING:
Applying the workpiece to the right side
of the disc first could cause workplece to fly up
(kickback) and result In an Injury.
\
\
MITER
GAUGE
ACCESSORYI
WORKPIECE
CENTER
WARNING:
For yourown
safety, turn switch"OFF"
and remove plug from pOwer source outlet before
aajustlng your sander.
NOTE: Use a combination square to square the miter
gauge to the face of the disc (combination _uare
must
be "true" - See "Unpacking - Tools Needed" section on
page 6 for checking this rnethod).
If it is not square,
loosen the miter gauge knob and move the miter gauge
slightly until it is square.
Without moving the miter
gauge, tighten the knob securely,
MITER
GAUGE
,ACCESSORY
COMBINATION
SQUARE
Always position the workpiece
to the left of center on
sanding disc with disc rotating counterclockwise
as
shown,
The table may be tilted for beveled work.
\
\
CENTER
J
WORKPIECE
(LEN
OF CENTER)
18
Advertisement
