JVC HX-Z1R Service Manual page 9

www.freeservicemanuals.info
Removing the rear panel
Prior to performing the following procedure, remove
the metal cover and the CD changer mechanism
assembly.
1. Remove holding board by remove two plastic rivets
and then slide out the holding board as shown in fig.
12.
2. Disconnect fan wire from connector CN206.
3. Cut off the tie band that tied fan wire on inner bar.
4. Remove eight screws F from rear panel.
5. Detach joint b to release rear panel from inner bar.
6. Release joints c which on right bottom and left
bottom of rear panel. The joint can be release by pull
outward the side of rear panel.
REFERENCE: Fan assembly will come off with rear
panel.
Joint c
Rear panel
(See Fig.12 ~ 17)
Rear panel
Fig.16
Joint c
Fig.17
Digitized in Heiloo Netherlands
Tie band
Joint b
Fan assembly
Fig.12
Holding board
Fig.13
Fig.14
F
F
Fig.15
HX-Z1R
Inner bar
Holding board Plastic Rivets
CN206
CN206
Rear panel
F
F
3/29/2018
1-9