JVC HX-Z1R Service Manual page 14

www.freeservicemanuals.info
HX-Z1R
Removing the display system control
board
1. Remove the four screws S
bracket (1).
2. Disconnect the card wire from connector CN43 and
CN880 on the display system control board.
Remove the ten screws T
system control board.
Removing the bottom board
Prior to performing the following procedure, remove
the display system control board.
1. Pull out preset knob, sound mode knob on the front
panel toward the front.
2. Remove the nut at volume knob encoder from front
panel.
3. Remove the four screws U
bracket (2).
4. Remove the eight screws V attaching the bottom
board.
U
Bottom board
Fig.34
1-14
(See Fig.31, 32)
attaching the stay
Stay bracket (1)
attaching the display
(See Fig.33 ~ 35)
attaching the stay
Sound mode knob
Stay bracket (2)
U
Digitized in Heiloo Netherlands
CN43
Fig.31
T
Display system control board
T
T
CN43
T
Fig.32
Front panel
Preset knob
Fig.33
V
Bottom board
V
Fig.35
S
Display system
control board
CN880
T
T
CN880
Volume knob
V
3/29/2018