Trouble Shooting; How To Transmit Or Receive A Message - PRESIDENT BILL FCC Owner's Manual

Table of Contents

Advertisement

Available languages

Available languages

- Dimensions inches
millimeters
- Weight
- Accessories supplied
2) TRANSMISSION
- Frequency allowance
- Carrier power
- Transmission interference
- Audio response
- Emitted power in the adj.
channel
- Microphone sensitivity
- Maximum drain
- Modul. signal distortion
3) RECEPTION
- Maxi. sensitivity at 20
dB sinad
- Frequency response
- Adjacent chan. selectivity : 60 dB
- Maximum audio power
- Squelch sensitivity
- Frequency image
rejection rate
- Intermediate frequency
rejection rate
- Drain
: 4.02 (W) x 3.94 (D) x 0.98 (H)
: 102 (W) x 100 (D) x 25 (H)
: ± 0.705 lbs / ± 0.320 kg
: Electret microphone with
support, mounting cradle,
quick fixation clip, screws.
: +/- 200 Hz
: 4 W
: inferior to 4 nW (- 54 dBm)
: 300 Hz to 3 KHz
: inferior to 20 µW
: 5.5 mV (elec.) / 2.2 mV (dyn.)
: 1.7 A
: 2 %
: 0.5 µV - 113 dBm
: 300 Hz to 3 kHz
: 2.5 W
: minimum 0.2 µV - 120 dBm
maximum 1 mV - 47 dBm
: 60 dB
: 70 dB
: 180 ~ 500 mA
E) TROUBLE SHOOTING
1) YOUR CB RADIO WILL NOT TRANSMIT OR YOUR
TRANSMISSION IS OF POOR QUALITY
-
Check that the antenna is correctly connected and that
the SWR is properly adjusted.
-
Check that the microphone is properly plugged in.
2) YOUR CB RADIO WILL NOT RECEIVE OR RECEP-
TION IS POOR
-
Check that the squelch level is properly adjusted.
-
Check that the volume is set to a comfortable listening
level.
-
Check that the microphone is properly plugged in.
-
Check that the antenna is correctly connected and that
the SWR is properly adjusted.
3) YOUR CB WILL NOT LIGHT UP
-
Check the power supply.
-
Check the connection wiring.
-
Check the fuse.
F) HOW TO TRANSMIT OR RECEIVE A MESSAGE
Now that you have read the manual, make sure that your
CB Radio is ready for use (i.e. check that your antenna
is connected).
Press the «push-to-talk» PTT switch (11) and announce your
message «Attention stations, transmission testing» which
will allow you to check the clearness and the power of
your signal. Release the switch and wait for a reply. You
should receive a reply like, «Strong and clear».
13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents