Sunbeam Rest & Relieve Therapeutic Mattress Pad User Manual page 27

R&R_MattressPad_IB-single
OPERATING INSTRUCTIONS
Adjusting Zones Individually
1 To adjust any zone individually,
press the "Select Zone" button that
corresponds to the zone you want
to change (ie. Feet Zone). That zone
will become outlined on the display
and will be the only zone that
changes when you press the " + "
and " – " buttons.
2 Press the " + " button to increase
or the " – " button to decrease the
heat of the selected zone.
3 To change another zone's setting,
simply select the zone and adjust
its heat level up or down.
NOTE: After customizing each zone, you may want to reset the " + " and " – " buttons to
again control all the zones of that side at once. To do this, turn off that side of the
Mattress Pad by pressing the ON/OFF button, then turn it back on. Or you can wait 60
seconds until the zone's outline disappears, then press the " + " or " – " button. Press the
ON/OFF button to turn off the side of the mattress pad that you want to reset.
14 For questions or support, please visit: www.sunbeam.com
12:21 PM Page 27
Selected zone will appear outlined