Sunbeam Rest & Relieve Therapeutic Mattress Pad User Manual page 17

R&R_MattressPad_IB-single
OPERATING INSTRUCTIONS
Adjusting Zones Individually
1 To adjust any zone individually, press the
"Select Zone" button that corresponds to the
zone you want to adjust. That zone will become
outlined on the display and will be the only
zone that changes when you press the
" + " and " – " buttons.
2 Press the " + " or " – " button to adjust the
heat of the selected zone.
3 To change another zone's setting, repeat
Steps 1 & 2.
NOTE: To Change all zones at once turn off the Mattress Pad and turn it back on. Or you can
wait 60 seconds until the zone's outline disappears, then press the " + " or " – " button.
Preheating the Mattress Pad
Never get into a cold bed again. Preheat warms your
Mattress Pad before you get in.
To preheat:
Turn Mattress Pad on by pressing the ON/OFF button.
Set your desired heat settings. Press the "Preheat"
button. All zones will show a "P" while they are
preheating unless a zone is turned off.
The zones will heat for 30 minutes and then return to
their previously programmed heat settings.
NOTE: To cancel preheat after activating it, press the "Preheat"
button again. The Mattress Pad's regular heat settings will resume.
NOTE: At least one zone must be selected for the preheat function
to work.
For questions or support, please visit: www.sunbeam.com
12:21 PM Page 17
Selected zone will
appear outlined
(optional)
Zones with
no heat setting (-)
will not preheat
9