Sunbeam Rest & Relieve Therapeutic Mattress Pad User Manual page 15

R&R_MattressPad_IB-single 12:21 PM Page 15
OPERATING INSTRUCTIONS
Turning the Mattress Pad ON and OFF
To turn on the Mattress Pad on or off press the "On/Off" button on the remote
control. When on, the base unit will beep once, the display will light up, and
all zones will appear outlined.
NOTE: The backlight turns off after one minute to save battery power, but the Mattress Pad
remains on. To turn the backlight on again, touch any button on the control other than the
"On/Off" button(s).
NOTE: The first time you turn on the control after installing or changing the batteries, the
display will show " – " in all zones.
Your customized heat settings are stored in memory so the next time you turn
it on, the Mattress Pad returns to the same preferences as the last session.
CAUTION: Always turn the Mattress Pad "Off" when not in use.
NOTE: Adjust zones before using preheat function.
Adjusting the
Highest Heat
Blue Zones at Once
Your Mattress Pad features 10
adjustable heat levels per zone that
can be increased or decreased
together or separately.
To adjust all the zones up or down
from their current settings, press the "
+ " button to increase or the " – "
button to decrease the heat. All the
zones will change together in the
same increments.
The display shows each zone's heat
setting: 1 through 9, and then H,
which is the warmest setting.
NOTE: A " – " on the display indicates that
Heat is Turned Off
the zone will not heat.
for this zone
8 For questions or support, please visit: www.sunbeam.com