Network Connectivity
SMB
Server Message Block (SMB) is a client server, request-response protocol that provides shared access
to files, printers, ports, and miscellaneous communications between nodes on a network.
Note:
For details on how to set up scanning to a shared folder, refer to
Overview.
To configure SMB:
1. In the Embedded Web Server, log in as administrator, then click Connectivity.
2. In the Protocols area, click SMB.
3. For Port, enable the toggle button.
4. If needed, for WINS Server Address Acquisition by DHCP, enable the toggle button.
5. If you did not enable WINS Server Address Acquisition by DHCP:
• For Primary WINS Server Address, type the IP address for your primary WINS server.
• For Secondary WINS Server Address, type the IP address for your secondary WINS server.
Note:
If DHCP is configured, WINS IP addresses are overridden.
6. Click OK.
60
Xerox
®
VersaLink
System Administrator Guide
®
Series Multifunction and Single Function Printers
Scanning Setup