Xerox VersaLink Series System Administrator Manual page 92

Security
To configure IPsec:
1. In the Embedded Web Server, log in as administrator, then click Connectivity→IPsec.
2. To enable IPsec, click the Enable toggle button.
3. To select a method of authentication, click IKE Authentication Method, then select an option.
• If you selected Digital Signature, click Device Certificate, then select an option.
• If you selected Preshared Key, for Preshared Key and Retype Preshared Key, type the key.
4. For IKE SA Lifetime, type the number of minutes that the printer waits before it terminates the
security association.
Note: The value for IKE SA Lifetime must be greater than or equal to the value for IPsec SA.
1. For IPsec SA Lifetime, type the number of seconds that the printer waits before terminating the
security association.
Note: The value for IPsec SA must be less than or equal to the value for IKE SA Lifetime.
1. To select a Diffie-Hellman group, click DH Group, then select an option.
2. To enable Perfect Forward Secrecy, for PFS, click the enable toggle button.
3. To specify an IPv4 address for the IPsec endpoint, for Specify Destination IPv4 Address, type the
IPv4 address.
4. To specify an IPv6 address for the IPsec endpoint, for Specify Destination IPv6 Address, type the
IPv6 address.
5. To allow communication with devices that do not use IPsec, click Communicate with Non-IPsec
Devices, then select Enabled.
6. Click OK.
M M a a n n a a g g i i n n g g S S e e t t t t i i n n g g s s f f o o r r S S S S L L / / T T L L S S
E E n n a a b b l l i i n n g g H H T T T T P P S S a a t t t t h h e e C C o o n n t t r r o o l l P P a a n n e e l l
1. At the printer control panel, log in as administrator, then press the Home button.
2. Touch Device→Connectivity.
3. Touch HTTPS.
4. Touch Enabled.
Note: When Secure HTTP is enabled, all pages in the Embedded Web Server contain https:// in
the URL for the webpage.
E E n n a a b b l l i i n n g g H H T T T T P P S S i i n n t t h h e e E E m m b b e e d d d d e e d d W W e e b b S S e e r r v v e e r r
1. In the Embedded Web Server, log in as administrator, then click Connectivity→HTTP.
2. To enable HTTPS, in the HTTPS (SSL) area, click the enable toggle button.
3. If needed, edit the settings for HTTPS Port Number, Maximum Connections, and Connection
Timeout.
92 Xerox ® VersaLink
System Administrator Guide
® Series Multifunction and Single Function Printers