Charger Controls - DieHard 200.71225 Operator's Manual

13.

CHARgER CONTROLS

13.1 dISPLAY MOdE BUTTON
Use this button to set the function of the digital display to one of the follow-
ing:
• BATTERY %:
the battery connected to the charger battery clamps.
• VOLTAgE:
clamps in DC volts.
• ALTERNATOR %:
centage of the vehicle's charging system connected to the charger bat-
tery clamps as compared to a properly functioning system.
13.2 BATTERY TYPE BUTTON
Use this button to set the type of battery to be charged to one of the fol-
lowing:
• 12V REgULAR:
motorcycles. These batteries have vent caps and are often marked "low
maintenance" or "maintenance-free."
• 12V dEEP CYCLE:
cycle" or "marine." Deep cycle batteries are usually larger than the other
types.
• 12V AgM/gEL:
vent caps. Such batteries are often smaller than the other types.
• 6V REgULAR:
ized vehicles. The 6V REGULAR battery type is not selectable for batter-
ies greater than 8.5V DC.
With the exception of AGM and Gel cell batteries, all other battery types
Digital Display
DISPLAY MODE
BATTERY TYPE
CHARGE RATE
The digital display shows an estimated charge percent of
The digital display shows the voltage at the charger battery
The digital display shows an estimated output per-
This battery type is usually used in cars, trucks, and
Deep cycle batteries are usually marked as "deep
AGM and Gel cell batteries have sealed cases without
This battery type is usually used in antique and special-
STATUS
CHARGED
CHARGING
CHECK
BATTERY%
VOLTAGE
ALTERNATOR%
12V REGULAR
12V DEEP CYCLE
12V AGM/GEL
6V REGULAR
2A SLOW
12A FAST
30A RAPID
80A START
11
• •