1. Manuals
  2. Brands
  3. DieHard Manuals
  4. Battery Charger
  5. 200.71232
  6. Owner's manual

DieHard 200.71232 Owner's Manual

Battery charger 60/20/2 amp fully automatic 275/125 amp engine starter with battery tester
Hide thumbs Also See for 200.71232:
Table of Contents

Advertisement

Quick Links

OWNER'S MANUAL
®
BATTERY CHARGER
60/20/2 Amp
Fully Automatic
275/125 AMP
ENGINE STARTER
With Battery Tester
Model No.
200.71232
CAUTION:
Read all Safety Rules and Operating Instructions,
and follow them with each use of this product.
Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.
00-99-000314/0103

Advertisement

Table of Contents
loading

Related Manuals for DieHard 200.71232

Summary of Contents for DieHard 200.71232

  • Page 1 60/20/2 Amp Fully Automatic 275/125 AMP ENGINE STARTER With Battery Tester Model No. 200.71232 CAUTION: Read all Safety Rules and Operating Instructions, and follow them with each use of this product. Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A. 00-99-000314/0103...

  • Page 3: Table Of Contents

    Warranty FULL THREE-YEAR WARRANTY If, within three years from the date of purchase this battery charger fails due to a defect in material or workmanship, RETURN IT TO THE NEAREST SEARS STORE IN THE UNITED STATES, and Sears will repair or replace it, free of charge.

  • Page 4: Important Safety Instructions

    – SAVE THESE INSTRUCTIONS – To reduce the risk of explosion, explosive gases, or injury while using your battery charger, follow the precautions listed below: • Do not disassemble charger. Take it to a qualified service professional if service or repair is required.

  • Page 5: Parts

    Parts This section shows an illustration of your battery charger. Use it to become familiar with where all the parts are located, and what they look like. Replacement Parts List DieHard 71232 Item Description Plastic Top Hub Cap Wheel Axle...

  • Page 6: Before Using Your Battery Charger

    Before Using Your Battery Charger It is important to prepare your charger for use. This section will tell you how to assemble the charger, ground and connect the power cord, and prepare to charge a battery. Assembling your charger It is important to fully assemble your charger before use.

  • Page 7: Plugging It In

    3. Tap the other axle cap onto the opposite end of the axle and place the axle assembly onto the bottom of the charger. Place one end of the bracket into slot, then place the axle assembly under each bracket. Fasten the other side of the brackets using the two 10-32 screws provided.

  • Page 8: Using An Extension Cord

    A TEMPORARY adapter may be used to connect the charger to a two-pole outlet if a properly grounded outlet is not available. Use the adapter ONLY until a properly grounded outlet can be installed by a qualified electrician. WARNING: Improper adapter con- nection can result in electrical shock.

  • Page 9: Using Your Battery Charger

    Using Your Battery Charger For best results from your battery charger, learn to use it properly. This section tells how to set the controls, charge a battery in or out of the vehicle, use the ENGINE START feature and test the battery.
  • Page 10 • TIME: To select a charging time, you must be in the MANUAL mode and have selected a charge rate. Touch the TIME pad until the desired time shows on the meter. The following chart shows the amount of time available for each charge rate and the amount of time, in hours, added for each touch of the TIME pad.

  • Page 11: Charging Your Battery

    • METER: Besides showing amps, volts, and time, the meter displays information: —A— Charge Rate in amps —V— Voltage Charger is in Manual mode AUTO Charger is in Automatic mode Charger is ready for cranking (Engine Start) WAIT Wait until the charger is ready before cranking again FULL Battery is charged (Automatic mode)
  • Page 12 (1) from the chassis connection and, (2) from the battery post or terminal. 14. Clean and store the battery charger in a dry location. Charging your battery outside the vehicle: 1. Remove the battery from vehicle, making sure to disconnect grounded terminal first with all accessories and lights turned off in the vehicle.

  • Page 13: Calculating Charge Times

    Calculating charge times The Chart Method Use the following table to more accurately determine the time it will take to bring a battery to full charge. First, identify where your battery fits into the chart. • Small batteries — motorcycles, garden tractors, etc. —...

  • Page 14: Using The Engine Start Feature

    Using the engine start feature Your battery charger can be used to jump-start your car if the battery is low. Follow these instructions when using the ENGINE START feature. 1. Set the POWER switch to the OFF position. Then follow the instructions for connecting the charger to the battery and power source in the section “Charging a battery in the vehicle.”...

  • Page 15: Troubleshooting

    Check for open fuse or circuit breaker supplying AC outlet. Circuit breaker cycles when current draw is too high. Check for shorted cables and replace if needed. Have a Sears Service Center test the battery. Correct connections. Correct touch-pad settings.

  • Page 16: For Information About Troubleshooting, Call Toll-Free From Anywhere In The U.s.a. 7 Am To 4:30 Pm Ct

    For information about troubleshooting, call toll-free from anywhere in the U.S.A. 7 am to 4:30 pm CT Monday through Friday. 1-800-SEARS-64 (1-800-732-7764). For repair parts or the location of a Sears Parts and Repair Center call: 1-800-4-MY-HOME ® (1-800-469-4663).

Table of Contents