10
Program interrupt
.03
If the course of a seam program is interrupted (e.g. a broken thread), the program interrupt
function must be called up.
The seam program course is interrupted after pressing the program interrupt key.
Sewing can continue manually and the values for the stitch length from the current seam
program are taken over.
The corresponding +/- key can be used to select the seam zone, in which the seam
program should be continued.
By pressing the program interrupt key again, the machine moves into the selected
seam zone and the programmed sewing function is continued.
10
Error messages
.04
When a fault occurs, the display shows "ERROR" together with an error code, as shown
in the following example. In addition, the LED in the memory card slot lights up red
(see arrow). An error message can be caused by the incorrect set up, faulty elements or
overloading.
Correct the error.
Confi rm the error correction if required by pressing the TE/Speed key.
The LED in the memory card slot lights up yellow (see arrow).
2
5
1
2.5
2.5
ERROR:
9
For a description of errors see chapter 11.07 Error codes and descriptions.
Sewing
53