Pfaff 1571 Instruction Manual page 32

Set-up and Initial Commissioning
8 Fitting the toothed belt / home position of the machine drive with the
.02.05
PFAFF 1571; 1591 and 1593
 Switch the machine on
2 x  Press the TE/Speed key twice to call up the input mode.
No  Select the parameter group "600" by pressing the corresponding +/- key.
 Confi rm the selection by pressing the corresponding +/- key.
 Enter the template code, see chapter 9.10 Entering/changing the template code.
 Select the parameter group "603" by pressing the corresponding +/- key.
 Turn the motor shaft by hand until the display shows the value "8".
 Turn the handwheel in the direction of rotation until the needle point (approaching from
 Lay on the toothed belt 1 while making sure that both the motor shaft 4 (Fig. 8 - 08) and
32
2.5 2.5
NO VAL
101
NO
600
NO
603
above) is on the upper edge of the needle plate.
the machine are not twisted.
II
8