LG WM2240CS Owner's Manual page 26

T roubleshooting guide
Using SmartDiagnosis™
• Only use this feature when instructed to do so by the call center.
The transmission sounds similar to a fax machine, and so has no meaning except to the call
center.
• SmartDiagnosis™ cannot be activated if the washer does not power up.
If this happens, then troubleshooting must be done without SmartDiagnosis™.
If you experience problems with your washer, call to Customer information center.
Follow the call center agent's instructions, and do the following steps when requested:
1. Press the POWER button to turn on the washer. Do not press any other buttons or turn the
cycle selector knob.
2. When instructed to do so by the call center, place the mouthpiece of your phone very close to
the POWER button.
3. Press and hold the WASH TEMP. button for three seconds, while holding the phone
mouthpiece to the icon or POWER button.
4. Keep the phone in place until the tone transmission has finished.
This takes about 15 seconds, and the display will count down the time.
• For best results, do not move the phone while the tones are being transmitted.
• If the call center agent is not able to get an accurate recording of the data, you may be asked
to try again.
• Pressing the POWER button during the transmission will shut off the SmartDiagnosis™.
5. Once the countdown is over and the tones have stopped, resume your conversation with the
call center agent, who will then be able to assist you using the information transmitted for
analysis at the call center.
26