Figure 10 Removing The Latch Assembly - Motorola Astro XTS Instruction Manual

Disassembling the Back
Housing Assembly
32
a. Using a small, flat-bladed screwdriver, deflect the long arm of
the kicker spring (3) in the direction the spring is wound,
until the arm clears the plastic.
b. Rotate the kicker counterclockwise until it reaches the stop.
c. Pull the kicker up and away from the pocket.
d. Remove the kicker spring.
19. Referring to Figure 10, remove the pocket lid housing (26):

Figure 10 Removing the Latch Assembly

a. Turn the pocket housing (5) upside down, so that the label
(28) side faces downward.
b. Insert a small, flat-bladed screwdriver at the base of the pocket
lid housing (26), and wedge the blade between the pocket lid
housing and the pocket housing.
c. Twist the screwdriver slightly clockwise while pulling outward
on the pocket lid housing. This will enable you to clear the
snap feature in the middle of the pocket lid housing and slide
the pocket lid housing away from the pocket housing.
20. Remove the purple eject button (27) from the pocket by sliding it
out of the groove.
21. Referring to Figure 10, pull on the latch assembly (6) and slide it
out of the pocket groove.
22. Remove the printed circuit board (PCB) assembly (11) by lifting
up on the back end of the PCB (the end with connectors). Pivot
the PCB at the volume knob until the PCB clears the volume knob
opening in the back housing (14).
Note: If charge contacts (12) require replacement, make sure
step 3 was performed. If this does not apply, skip step
23 and continue with step 24.
Pocket Groove
Latch Assembly