Xtva Troubleshooting Kit Procedure; Figure 14 Reassembling The Universal Subassembly - Motorola Astro XTS Instruction Manual

Completing the Console
Reassembly
XTVA
Troubleshooting Kit
Procedure
36

Figure 14 Reassembling the Universal Subassembly

19. Align the hole in the universal header subassembly with the pin
in the pocket and the hole in the link to the chassis boss. Push the
universal header subassembly fully downward and under the
corner of pocket actuator.
20. Insert the RF connector (mini-UHF or BNC type) into the slot in
the chassis. Make sure that the washer is inserted in the slot and is
making a positive ground connection.
21. Insert the coaxial cable into the retaining feature on the chassis.
22. Insert the two hex nuts into the slots so that the round side faces
inward.
23. Insert the lock into the slot above the volume knob so that the
gold dot faces upward.
24. Reassemble the top cover. Make sure the flex circuit ribbon is not
pinched.
25. Turn the unit upside-down and torque the five back cover screws
to 8 in-lb, using a T-15 TORX driver.
26. If the product label was removed while disassembling the unit,
replace it in the recess.
27. Finally, inspect the coaxial cable for proper routing through the
specified openings in the top cover. Ensure that the cable has not
been dislodged from the cable retaining features.
Note: This procedure is continued from step 9 of the disassembly
procedure.
Refer to the exploded view and exploded view parts list on page 54. Items in
parentheses ( ) refer to item numbers in the exploded view.
RF Connector
Universal Header
Assembly