Table of Contents
Advertisement
Available languages
Available languages
3. I
NSTALLATION
3.1 I
C
NSPECT THE
ONTENT OF THE
NOTE: Before proceeding to the installation, check the content of the box. Remove all packaging material from the unit.
•
Inspect the exterior of the unit for shipping damage. Ensure that there is no damage to the door, ports, power cord, etc.
•
Using a Phillips or a Robertson screwdriver, loosen both door screws (A).
NOTE: The screws will stay attached to the door.
•
Open (B) and lift out (C) the door.
In order to prevent damages to the door hooks, do not open completely the
unit door; tilt it about 3" from the unit base and lift it up. See illustration at
right.
•
Remove the transport tape over the heat or energy recovery core
of the unit.
•
Inspect the inside of the unit for damage. Ensure that blower
assembly, heat or energy recovery core, core filters, insulation,
dampers, prefilter and HEPA filter, etc. are all intact, then reinstall
the door.
NOTE: Write the installation date on the HEPA filter frame for future
reference (see illustration at right).
B
OX
CAUTION
VD0322
5
A
VD0302
C
±3"
B
VD0303A
Advertisement
Chapters
Table of Contents
