Trouble-Shooting - One for All 4 User Manual & Code Book

Trouble-Shooting

Problem: Solution:
Red light does not Replace batteries with 4 fresh,
blink when you press new AAA alkaline batteries.
a key?
The ONE FOR ALL Make sure you are using new
does not respond after batteries and are aiming the
pressing a key? ONE FOR ALL at your device.
The ONE FOR ALL A) Try all the codes listed for
does not operate your your brand. B) Try the search
device(s)? method on page 11.
When following the Did you use the Code Lock
set-up instructions, the feature? You must first unlock the
red light on the ONE code before entering a new code.
FOR ALL only blinks Follow the instructions on page
once instead of twice 20 to do this.
after you enter a
three-digit code?
Your brand is not Try the search method on page 11.
listed in the ONE FOR
ALL code section?
The ONE FOR ALL You may be using the wrong code.
is not preforming Start the search method over
commands properly? again to locate the proper again.
Press a key but get Hold MAGIC until the red light
the wrong result? blinks twice, then press 992 and
the device key twice. You will
need to set-up your device again.
Try the codes for brand or the
search method on page 11.
You cannot control the Hold MAGIC until the red light
volume feature of your blinks twice. Then press 993 and
Satellite, Cable VOL+. To set the volume control
Converter or TV/Video back to TV (Punch Through),
Combination? hold MAGIC until the red light
blinks twice, then press 993 TV.
Problems changing Enter the programme number
channels? exactly as you would on your
original remote.
Video not recording? As a safety feature on your ONE
FOR ALL, you must press the
Record key twice .
Scan does not work Make sure your original remote
on your device? had a programme +/- key.
21
All manuals and user guides at all-guides.com