QSC TouchMix Series Quick Start Manual page 4

— Figure 10 —–
— Figure 11 —–
— Figure 12 —–
— Figure 13 —–
— Figure 14 —–
Steinberg Cubase
1. Open Cubase.
2. To select TouchMix-30 Pro as the audio device, go to Devices > Device
Setup... > VST Audio System. At ASIO Driver, select QSC TM30 Pro
(Figure 10).
3. Click OK.
4. To assign TouchMix-30 Pro inputs to the Cubase buses, go to Devices > VST
Connections > Inputs.
5. Select and delete any existing connections.
6. Click Add Bus. The Add Input Bus window will open (Figure 11).
7. In Count, select the number of mixer channels to assign to buses. For
example, select 30 if you wish to add all of them. NOTE: Some entry-level
versions of Cubase support only 16 buses.
8. In Configuration, select Mono.
9. Click Add Bus. The mixer inputs will map one-to-one to the DAW buses
(Figure 12).
10. To assign Cubase outputs to TouchMix-30 Pro inputs, go to Devices > VST
Connections > Outputs.
11. As in assigning the Cubase inputs, select and delete any existing connections.
Click Add Bus to set the channel count and configurations. When you have
finished, click Add Bus.
12. To connect mixer inputs to DAW tracks, first select a track. Look in the
Inspector window or at Track Controls and find the e (edit channel settings)
symbol.
13. Click e. The Channel Settings window will open.
14. On the DAW track you wish to assign, click the box to the left of the track
number and name.
15. Select the bus that you want to feed this track. For example, see Figure 13.
Track 2 is portrayed. Selecting Mono In 2 assigns mixer channel 2 to Track
2. Therefore, the signal flow is TouchMix-30 Pro input channel 2 to Cubase
Mono In 2 to Cubase Track 2.
Repeat for other tracks.
16. To connect DAW buses to TouchMix-30 Pro input channels, first select a track.
As in the earlier steps, look in the Inspector window or at Track Controls and
find the e (edit channel settings) symbol.
17. Click e. The Channel Settings window will open.
18. On the DAW track you wish to assign, click the box to the right of the track
number and name.
19. Select the bus you wish to have this track feed. For example, see Figure 14.
Track 2 is portrayed. Selecting Mono Out 2 assigns mixer channel 2 to Track
2. The resulting signal flow is Cubase Track 2 to Cubase Mono Out 2 to
TouchMix-30 Pro input channel 2.
Repeat for other tracks.
4
macOS, Windows