QSC TouchMix Series Quick Start Manual page 2

Configuring iOS Core Audio
Configuring Apple iTunes Playback
— Figure 3 —–
— Figure 4 —–
— Figure 5 —–
— Figure 6 —–
— Figure 7 —–
6. The installer will copy the files to the selected location. When it is done it
will present a message that the driver has been installed on your computer
(Figure 3). Click Finish.
Connection
1. Use a Type B USB cable (Figure 4) to connect the mixer's USB DAW port to a
USB port on your computer.
1. To connect a TouchMix-30 Pro to a Mac DAW, start by connecting a Type B
USB cable (Figure 4) to the USB DAW port on the mixer. Then connect the
other end to your computer's USB jack.
2. On the TouchMix, push Rec/Play > Recording Mode > and select
Multitrack DAW.
3. Open the Audio MIDI Setup utility on the Mac (Finder > Applications >
Utilities > Audio MIDI Setup). If the audio window isn't already visible, go
to the Window tab and select Show Audio Devices.
4. QSC TM30 Pro will appear in the Audio Devices window (Figure 5). Select
the mixer and make sure the sample rate on the computer matches that of the
mixer. The TouchMix sample rate may be set from its Rec/Play screen.
1. In the list of audio output devices, select QSC TM30 Pro device in the Audio
MIDI Setup list. Then right click on it and select Use this device for sound
output. See Figure 6.
2. Click Output; then click Configure Speakers... at the lower right.
3. Verify that Stereo is selected. Click Left Front and select Q 31. Click Right
Front and select Q 32 (Figure 7). This will route iTunes music to the mixer's
2-Trk PB channel. Any other pair of channels may be used instead, but the
mixer would need to be in DAW mode, with Track selected as their input
source.
4. Click Done.
2